Great Plains 2007HD Update Installation - Manual (Page 56)

166-370M Table of Contents Index 05/25/2011
52 NTA607HD or NTA2007HD Table of Contents Index Great Plains Manufacturing, Inc.
Install Rear Pull Link
Pin Link to Main Frame
Refer to Figure 84
311. Connect a hoist to the new:
160-316H NTA607HD REAR PULL LINK WELDMT
The lug is down after installation. The weldment
may be shipped on a pallet with the lug up.
312. Select two saved:
160-201H WING PIVOT PIN WELDMENT
313. Hoist the link into alignment with the implement
main frame. Insert pins to secure.
314. Select two saved:
805-255C PIN ROLL 3/8 X 2 1/2 PLT
and six:
804-039C WASHER FLAT 1 1/4 SAE PLT
Place the washers on the pins just installed.
Secure with roll pins .
Connect Lift-Assist Link
Refer to Figure 85
315. Select one saved:
160-781D PIN 1 1/2 X 4 USABLE 1045
and two sets saved:
805-117C PIN ROLL 1/4 X 2 1/2 PLT
804-117C WASHER FLAT 1/4 HARD ASTMF436
316. Bring the lift link clevis into alignment with the
pull link lug. Connect with pin . Secure pin with a
washer and roll pin on each end.
Figure 84
Install New Rear Pull Link
Q0115
193
200
104
903
903
104
903
104
200
193
193 104
200
Figure 85
Re-Connect Rear Lift Link
Q0122
113
118
196
194
118
196
194
113
118
194 196