Great Plains 2007HD Update Installation - Manual (Page 28)

24 NTA607HD or NTA2007HD Table of Contents Index Great Plains Manufacturing, Inc.
166-370M Table of Contents Index 05/25/2011
Install Pull Bar Attach Points
Install Pull Bar Plate
Refer to Figure 37 and Figure 38
125. Remove the hitch casting
from the tongue.
126. Remove the paint from the lower inside surfaces of
the front tongue side plates .
127. Select one new:
266-300D NTA2007 PULL BAR BOLT PLT
128. Position the plate for tack welding inside the tongue.
One method would be to place four 13 mm clamps
along the bottom edges of the hitch side plate. Rest
the bolt plate on the clamps. Check alignment.
129. Tack weld the bolt plate to the hitch plates. Finish
weld all around with a 13 mm (
1 ⁄
2
in) fillet.
130. Remove all slag and splatter. Clean and de-grease.
Allow welds to cool.
131. Paint all bare and discolored surfaces of the bolt
plate and hitch side plates.
Note: Pull bars are installed at step 161 on page 28.
Figure 37
Plate and Pull Bars
Q0105
922
133
123
123
133
123
922
Figure 38
266-300D Plate Alignment
Q0106
922
21.1
°
25.5 cm
10.04in
13 mm
0.5 in
13 mm
0.5 in
123