Exide Technologies Section 94.40 - Manual (Page 9)

INSTALLING THE AT30
5
PROCEDURE (Style-5030)
1. Install four (4) 0.375 / 9.5mm or 0.5in/12.7mm bolts into the floor per
mounting dimensions featured in the outline drawing (
JE5086-00).
2. Using the methods described in Section 1.4, carefully lift the AT30 above
the floor-mounting bolts. Guide the enclosure onto the floor bolt pattern and
lower it into place.
3. Add appropriate mounting hardware (0.375 / 9.5mm or 0.5in/12.7mm), onto
the floor-mounting bolts and tighten securely.
PROCEDURE (Style-163)
1. Install four (4) 0.5in/12.7mm bolts into the floor per mounting dimensions
featured in the outline drawing (
JE5095-00).
2. Using the methods described in Section 1.4, carefully lift the AT30 above
the floor-mounting bolts. Guide the enclosure onto the floor bolt pattern and
lower it into place.
3. Add appropriate mounting hardware (0.5in/12.7mm), onto the floor-
mounting bolts and tighten securely.
STANDARD NEMA-1 AT30 ENCLOSURE TYPES
Style-5018
see outline
JE5085-00
Style-5030
see outline
JE5086-00
Style-163
see outline
JE5095-00