Exide Technologies Section 94.30 - Manual (Page 98)

MANUAL SPECIFICATIONS
94
DOCUMENT NUMBER
The text and graphics contained within this manual are controlled by the battery charger
manufacturer's internal part number ( JA5018-00). The revision level and dates of this manual's
text and graphics are listed below. These controls supercede all other available dates. The first
two and last two pages of this manual are reserved for company-specific front and back cover
artwork. Any revision levels, revision dates, or document numbers featured on the first two and
last two pages of this manual refer to the cover artwork only.
DOCUMENT INFORMATION
Document Number: JA5018-00
Revision Level: 6
Engineering Change Number:
22150
Electronic Filename: [ JA5018-00.Rev6.doc ]
Last Date Saved: [ 5/27/2010 7:15 PM ]
Last Date Printed: [ 5/27/2010 7:30 PM ]
PARTS DATA PACKAGE
Any job-specific customized Parts Data Package report supplied with this battery
charger and/or this manual supercedes the information featured in the standard parts list
starting on page 62. The data in that particular document is applicable only to the battery
charger featuring the same serial number listed on the Parts Data Package report.
DRAWINGS
A customized record drawing package is available for your AT10.1, featuring a unit-
specific drawing list / data nameplate detail, outline drawing, itemized internal component
layout, electrical schematic with component ratings, and a full connection diagram. If the
standard drawings featured in this manual are not sufficient, please contact your Sales
Representative for drawing availability from the battery charger manufacturer.
Any job-specific custom drawings supplied with your AT10.1 and/or this manual,
supercede the standard drawings featured in Appendix C. The standard drawings and
corresponding page numbers featured in this section may not be included with custom printed
manuals, when job-specific custom drawings are supplied.