Installation instructions – SoundOff Signal nFORCE® Interior Traffic Controller User Manual
Page 9
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800.338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
nFORCE® LED Traffic Controller - Interior Use Only
ENFTCDGS12(xx)
nFORCE Traffic Controller 9.14
INSTALLATION INSTRUCTIONS
1. Locate where you want to install the
nFORCE Traffic Controller.
2. Using the screw holes on the mounting
brackets as a template, mark the hole
locations on the vehicle.
3. Drill screw holes.
4. Screw the mounting bracket to the
vehicle using user supplied screws.
5. Slide T-Bolts into the channel on the back
of the Traffic Controller.
6. Choose the height you would like to
mount your Traffic Controller and insert
the T-Bolt into the coordinating hole being
sure that it is oriented correctly. The side
with the "BOTTOM" label should be facing
down.
7. Tighten the Traffic Controller onto the
mounting bracket with the supplied flat
washer and nut.
Alternate Mounting Bracket Options
9.
TRAFFIC CONTROLLER
T-SLOT BOLT x2
FLAT WASHER x2
NUT x2
USER SUPPLIED
MOUNTING SCREW x4
MOUNTING BRACKET x2