SoundOff Signal nFORCE® Interior Traffic Controller - Manual (Page 2)

IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800.338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to [email protected].
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
nFORCE® LED Traffic Controller - Interior Use Only
ENFTCDGS12(xx)
nFORCE Traffic Controller 9.14
POWER SPECIFICATIONS
Input Voltage Range: 10 -16 Vdc
Light Bar
Component
Current Draw
(Average = Flashing)
Power Consumption
(Watts)
Standby Current
Ignition ON Ignition OFF Ignition ON Ignition OFF
0.010 Amps 0.002 Amps 0.13 Watts 0.03 Watts
Reverse Polarity Protected
Wiring
Power Cable 15ft 18 AWG Wires, (+) Red, (-) Black,
(Data) White
TECHNICAL SPECIFICATIONS
Material:
Housing: Aluminum Alloy
Lens: Polycarbonate
Operating Temperature: -40º to +65º C
2.
VIEW FROM SIDE
VIEW FROM FRONT
ELECTRICAL INSTALLATION
Featured Highlights & Terminology:
Mode Select: The nForce Traffic Controller is equipped with 4 selectable pattern configuration modes. The default input wire configuration allows
for 2 modes, and an additional 2 modes may be configured with the PC Application using any available input wires. Default is Mode 1 where the
Mode select input is floating, Mode 2 is in use when the input activated. This feature allows up to 4 completely different sets of patterns to be
programmed into the Light-bar's non-volatile memory. Once programming configuration is complete, the Mode can be changed “on-the-fly” by an
activation switch which applies voltage to the Mode input wire(s).
Front & Rear Installations:
Cruise Mode: Allows the user to program any light group(s) to “Glow” when this feature is activated. For dual / tri color bars, the color for each
light group is selectable.
Takedown Mode: Allows the user to program any Light Head Group(s) to turn on steady when this feature is activated to provide steady ON
takedown lighting.
Steady ON Mode: Accessable with PC App only and allows the user to program any light module to turn on steady at 50% duty cycle.
Scene Light Mode: Allows the user to program any Light Head Group(s) to turn on steady when this feature is activated to provide additional
scene lighting. The activation of this input also activates the Takedown function