E-flite Super Cub 25e ARF - Manual (Page 5)

5 E-flite Super Cub 25e ARF Assembly Manual
We recommend installing the lighting kit and
interior in the sequence of steps shown in the
manual. Adding these items after the model is built
may not be possible without causing damage to
your airframe. Please decide prior to beginning
construction whether or not you would like to
incorporate these items in your airplane.
Required Tools and Adhesives
Tools & Equipment
Box wrench: 10mm Felt-tipped pen
Low-tack tape Flat blade screwdriver
Isopropyl alcohol Hobby knife with #11 blade
Paper towel Nut driver: 1/4-inch
Petroleum jelly Phillips screwdriver: #1, #2
Pin vise Pliers
Ruler Scissors
Side cutters Square
Toothpick T-pins
Mixing sticks Mixing cups
Dental floss Sandpaper
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm),
7/64-inch (3mm)
Hex wrench: 1.5mm, 2mm, 3/32-inch, 5/64-inch,
1/8-inch
Optional Tools & Equipment
Balancing stand (optional)
Adhesives
30-minute epoxy PAAPT39
Medium CA PAAPT02
Thin CA PAAPT08
Threadlock PAAPT42
Formula 560 Canopy Glue PAAPT56
Before Starting Assembly
Before beginning the assembly of your model, remove
each part from its bag for inspection. Closely inspect
the fuselage, wing panels, rudder and stabilizer for
damage. If you find any damaged or missing parts,
contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun
(HAN100) and covering glove (HAN150) or covering
iron (HAN101) with a sealing iron sock (HAN141) to
remove them. Use caution while working around seams
or areas where the colors overlap to prevent pulling
the seams.
During the course of building your model, we
suggest you use a soft base for the building surface.
Such things as a foam stand, large piece of
bedding foam or a thick bath towel will work well
and help protect the model from damage during
assembly. This is not shown in the instructions
to provide the greatest detail in the photos.
When referencing directions (up, down, left,
right, top and bottom), take note that these are
in relationship to the pilot sitting in the cockpit
of the aircraft unless noted otherwise.
hinging the Ailerons and Flaps
Required parts
Wing panel (right and left)
Aileron (right and left)
Flap (right and left) Flap hinge (6)
CA hinge (8)
Required Tools and Adhesives
Side cutters Petroleum jelly
T-pins Toothpicks
Thin CA Low-tack tape
Pin vise Drill bit: 1/16-inch (1.5mm)
30-minute epoxy Isopropyl alcohol
Mixing sticks Epoxy cups
Paper towel
 1. Locate the wing panel. Separate the aileron and
flap from the wing panel by removing the tape
holding them to the wing panel.