E-flite Super Cub 25e ARF - Manual (Page 26)

26 E-flite Super Cub 25e ARF Assembly Manual
 E. Carefully solder the extension to the light.
Use care not to melt the wiring by leaving the
soldering iron in position too long. Make sure to
stagger the solder joint so the wires will fit into
the tube in the rudder. Use heat shrink tubing to
protect the connections.
 F. Press the light into position in the rudder. It
may be necessary to use a very small amount of
silicone adhesive to keep the light in position.
Tail Wheel Installation
Required parts
Fuselage assembly Tail wheel bracket
Tail wheel spring (2)
2mm x 10mm washer head self-tapping screw (2)
Required Tools and Adhesives
Thin CA Phillips screwdriver: #1
Pliers Ruler
Side cutters
 1. Use a #1 Phillips screwdriver to thread a 2mm
x 10mm washer-head self-tapping screw into each
of the holes to cut threads in the surrounding wood.
Remove the screw before moving to the next step.
 2. Apply 2–3 drops of thin CA in each of the holes
to harden the surrounding wood. This will harden
the threads so the screws do not easily strip the
surrounding wood.
 3. Install the tail wheel bracket using two 2mm x
10mm washer-head self-tapping screws and a #1
Phillips screwdriver.