E-flite Super Cub 25e ARF - Manual (Page 14)

14 E-flite Super Cub 25e ARF Assembly Manual
 5. Place the speed control in the fuselage. Use two-
sided tape to secure the speed control in the fuselage
so it rests against the landing gear mount.
 6. Connect a 9-inch (228mm) servo extension to the
speed control lead. Use a string or piece of dental
floss to secure the lead so it does not accidentally
disconnect inside the fuselage.
 7. Mount the switch in the fuselage using the
hardware provided with the speed control.
 8. Guide the extension along the bottom inside the
fuselage. Run the extension back as far as it will
go. Use low-tack tape to prevent the extension from
falling forward in the fuselage until it is plugged
into the mounted receiver.
Cowling, propeller and
Flight Battery Installation
Required parts
Fuselage assembly Cowl
Propeller
Spinner assembly (not included)
Motor battery Hook and loop strap
Hook and loop tape
Required Tools and Adhesives
Box wrench: 10mm
Hex wrench: 3/32-inch
 1. Slide the cowling on the fuselage. The dowels in
the fuselage will position the cowl and the magnets
will hold the cowl to the fuselage.