E-flite Super Cub 25e ARF - Manual (Page 33)

33 E-flite Super Cub 25e ARF Assembly Manual
 8. Use medium CA to glue the seat supports in
the fuselage. Make sure the CA has fully cured
before proceeding.
 9. The seats are held in position with magnets so
they can be removed when installing the wing
bolts. Install the seats as shown. Please note that the
prototype seats are shown; the production seats are
darker in color.
Cockpit Kit Installation (Optional)
Required parts
Fuselage assembly Cockpit kit (optional)
Required Tools and Adhesives
Medium CA Two-sided tape
You can use two-sided tape to secure the floor so it can
be removed in the future, should a component need to
be replaced or a repair to the airframe is necessary.
 1. Test fit the pieces of the cockpit kit into the
fuselage. Start by installing the thin plastic floor,
then the thin painted side pieces. The covered
wood side rails are then installed. Once these items
have been fit, you can use medium CA to glue
them in position in the fuselage. Finally, install the
control stick, control pedals and instrument panel in
the fuselage.