E-flite Super Cub 25e ARF - Manual (Page 24)

24 E-flite Super Cub 25e ARF Assembly Manual
 6. Attach the rudder tiller arms using a 2mm x 12mm
machine screw and 2mm nut. Position the tiller arms
so they face toward the bottom of the rudder and
forward towards the hinge line as shown.
 7. Place a T-pin in the center of each of the three
hinges. This will center the hinges equally in the
aileron and wing when they are installed.
 8. Insert the hinges in the rudder. The T-pin will rest
on the edge of the rudder bevel.
 B. Use side cutters to remove the plug from the
clear light. Check the fit of the light in the tube in
the rudder. It may be necessary to use a hobby
knife and #11 blade to remove some material
from the rudder to make the light fit flush to the
trailing edge of the rudder. Remove the light once
the fit has been made.
 C. Remove the end of the 36-inch (915mm)
lighting extension. Make sure the end that remains
is the end that plugs into the lighting controller.
Slide the extension through the tube in the fuselage
and out at the rudder hinge line.