E-flite Super Cub 25e ARF - Manual (Page 38)

38 E-flite Super Cub 25e ARF Assembly Manual
 7. Repeat steps 1 through 3 to prepare and install
the navigation light. When installing the navigation
lights, the red will be on the left, and the green will
be on the right. Leave the light extended out so it is
visible in the navigation light cover when the cover
is installed.
 8. Install the navigation light cover using canopy
glue. The fit should be tight, so tape will not be
needed to hold the cover in position.
 9. Use the template on page 45 to make the cover
for the navigation light lens using adhesive-backed
Ultracote trim sheet.
 10. Repeat steps 1 through 3, and 7 through 9 to
install the remaining navigation light.
Accessory Installation
Required parts
Wing panel (right and left)
Landing light cover Navigation light cover (2)
Required Tools and Adhesives
Canopy glue
 1. Use canopy glue to glue the landing light cover
to the wing. Use low-tack tape to hold the cover in
position until the glue fully cures.
 2. Install the navigation light cover using canopy
glue. The fit should be tight, so tape will not be
needed to hold the cover in position.