Banner A-GAGE MINI-ARRAY Series - Manual (Page 34)

34
P/N 43298 rev. E
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
MINI-ARRAY ®
Instruction Manual
Figure 5-22. MINI-ARRAY software: Retrieve PSF screen
Retrieving a PSF from Disk
To retrieve a filed PSF, select File Retrieve PSF. The FileBox subscreen will appear
(Figure 5-22). Select the desired PSF from the File Name list and then select OK or
press the Enter key. The selected PSF will load to the PSF Configuration screen and
can be loaded into the controller using the Send PSF command.
PSF Output Analysis
To view activity in the array in response to the currently loaded PSF, select Execute.
The Measurement Output screen will appear (Figure 5-23). Select Run. The table will
display the status for the selected measurement mode(s), including the Present value,
and the High and Low values for the Run
period.
Select Stop to freeze the data. Select Step
to initiate a single scan of the array. This
simulates a “snapshot” of what is viewed
by the array when Step is selected.
Use of the Execute command is
especially beneficial for testing the
response of a gated system. Run
simulates the Continuous scanning
mode, and Step simulates a gate input
command.
To close the PSF Configuration screen,
select either Quit or Exit.
Figure 5-23. MINI-ARRAY software: PSF Output Analysis
Controller Configuration