Metrohm NIRS XDS RapidLiquid Analyzer - Manual (Page 59)

▪▪▪▪▪▪▪ 57
XC-1310 Transmission Standard Set contains a
10% transmission standard (T033xxxx) which may
be used for this test, if desired.
The T03 transmission standard may be positioned
in the sample drawer.
Vision closes the drawer to run the Low Flux Test
when using an external sample (standard).
If the user clicks “No” to the external standard, then Vision will automatically trigger the 10% internal
screen for this test. No user action is required.
Vision runs the Low Flux Test, which takes about 10 minutes. At the end, the results are displayed. A
typical run is shown:
Click on the tab marked “Summary” to see the summarized results as compared to acceptance