Metrohm NIRS XDS RapidLiquid Analyzer User Manual
Page 36
34
▪▪▪▪▪▪▪
are accomplished on only 16 grating cycles, and are very rapid. Click “OK” when finished.
The user may check test parameters, Click the “Test Param” button, then select the wavelength area
of interest. Specifications will be displayed.
The user will hear a slight ticking sound from the internal order sorter whenever the lamp is on. This
is normal, and has no effect on component life. The parts are kept in motion to reduce “wait time”
before instrument stabilization.
Upon successful connection, the sample drawer will quietly open. Do not manually force the sample
drawer to either an open or closed position. It is under software control.
Next, select this DCM from the selection box.
Click “OK” to connect to the instrument.
Once connected, verify that the amber
“Communication” LED is lit on the instrument
Upon connection, Vision will prompt for the
instrument configuration. This is used to
establish a Diagnostic Database.
Vision reads the sample module serial number
and enters it in the blank field. Verify that this
number is correct. It is important that the
instrument be correctly identified, to prevent
corruption of the database.
If correct, accept the information and click
“OK”.