Metrohm NIRS XDS RapidLiquid Analyzer User Manual
Page 25
▪▪▪▪▪▪▪
23
9.
Lift the release handle on the
monochromator and engage the module
“catches” to the locking togs on the
monochromator. (Module not shown to
allow a good view of handle.)
Push monochromator and module together
firmly (with handle up) then lower the
release handle.
10.
When the catches are fully engaged to the
locking togs, push the release handle down
all the way.
This automatically engages the electrical
connector and fiber optic interface, and
maintains proper alignment of the module
to the instrument.
The final assembly is as shown. Note that
the sample drawer is closed. It will open
upon power-up. Do not attempt to open
the drawer manually.
11.
Plug the AC power cord into a grounded AC outlet. A surge protector or Uninterruptible
Power Supply (UPS) is recommended for best operation.
12.
If using a network, use a non-crossover type
cable (“patch cable”) as listed in section 3.0.
Plug the RJ-45 network connector into a
functional network port.
If this requires approval from a network
administrator, it should be properly approved
for hookup.
For “Direct Connection” the gray cable from
the instrument plugs directly to the computer
network jack. (Use the cable supplied with
the instrument.)