Metrohm NIRS XDS RapidLiquid Analyzer - Manual (Page 33)

▪▪▪▪▪▪▪ 31
Vision asks if the default directory location is
acceptable.
Click on “Yes”. Vision creates a directory for
the project as shown.
Vision prompts the user to connect to the
instrument. Be sure the instrument is turned
on and is ready.
Click on “Acquire New Data”.
This screen sets up communication
parameters for the instrument. The XDS
instrument has a unique driver. Highlight this
box and click on “Configure”.
This box allows the user to set
the COM port and select the
instrument IP (Internet Protocol)
address.
Use the drop-down arrow of the
IP Address box, and select the
correct instrument. The
instrument must show
“Available” to be selected.
Click “OK” to exit the dialog box.
When preparing to run samples, the user may wish to enable “Blank Correction” as