Metrohm 761 SD Compact IC - Manual (Page 93)

5.2 Operation with automated sample change
761 SD Compact IC / Instructions for Use 8. 761.1043
85
5.2.1.2 Creating the sample table (automated operation / «IC Net»)
1 Open a new sample table
⇒ Choose IC NET / File / Open / Sample Queue... , the OPEN
SAMPLE QUEUE window opens.
⇒ Enter a file name and choose .
2 Create the sample table
⇒ Create the sample table (see Software Instructions for Use «IC
Net 2.3», Section 9.2). You should first perform a conditioning
step with system
startup.smt
. Then perform the calibration
measurements and sample determinations with system
auto.smt . Assign the number for Vial to the rack positions you
have selected. Example of a sample table:
⇒ If Shut down system after the queue finishes is activated, you do
not need to run system shutdown.smt at the end.
If your sample sequence corresponds to an existing sample table, you
can open it with IC NET / File / Open / Sample Queue... or via a system
SYSTEMS / System / Sample Queue... .
5.2.1.3 Starting the sample table
Start the open sample table by clicking on (see Software In-
structions for Use «IC Net 2.3», Section 9.2.2)