Metrohm NIRS XDS Process Analyzer – SingleFiber - Manual (Page 60)

58 ▪▪▪▪▪▪▪
3. This box allows the
user to select the
instrument identified
by the instrument
serial number.
The number in front
of the instrument S/N
is the IP (Internet
Protocol) address
assigned to the XDS
instrument.
If no instrument is shown, of if it is not “Available”, click “Retry” to clear the communication
ports.
Use the drop-down arrow of the IP Address box, and select the correct instrument. The
instrument must show “Available” to be selected.
4. Highlight the instrument, then Click “OK” to exit the dialog box.
5. If the data to be acquired will be used
on other similar instruments, it is
advisable to enter Configure, Options
from the menu bar.
This should be done before setting up a
Data Collection Method (DCM).
6. Select Options as shown at right.
Reference Standardization and Use
Instrument Calibration are essential for
method transfer between similar
instruments. Check both boxes, then
click on “OK”.
This screen is discussed in more detail in
section 10.1 of this manual.