Metrohm NIRS XDS Process Analyzer – SingleFiber - Manual (Page 50)

48 ▪▪▪▪▪▪▪
Install the O-ring onto the cable connector
housing as shown. Do not damage or distort
the O-ring during installation.
Slide the cable connector housing onto the RJ-
45 cable as shown.
Using the correct type of crimping tool, crimp
the RJ-45 connector jack onto the cable. Be
sure the conductors are arranged in the proper
order and are in the designated positions for
crimping.
Push the RJ-45 jack fully into the connector
housing. Install the locking clip as shown to
hold the jack to the connector housing.
Note that the locking clip must be oriented as
shown, with the flat center projection toward
the jack. When in place, push down fully.
Tighten the hex collar onto the connector
housing. Apply enough torque to fully compress
the seal over the cable end.