Metrohm NIRS XDS Process Analyzer – SingleFiber - Manual (Page 46)

44 ▪▪▪▪▪▪▪
11. Route AC Mains wiring into the housing, and in
to the Main Power Wiring Header as shown at
right.
Terminals 3 and 6 should be left as is, with the
black and white wires attached.
Use table below for wire color codes.
L1, Neutral L2, HOT Ground
Intl: Blue
US: White
Intl: Brown
US: Black
Intl: Green/Yellow
US: Green
12. Attach Grounds to the Ground Lug inside the Base Unit of the EPCU.
13. The wiring diagram on page 13 of the BEBCO Industries Series 4000 manual is shown for
reference. Refer to the actual diagram for complete wiring particulars.
Follow the actual wiring diagram in the BEBCO manual.
14. Verify that all wires are secure and that the clamping screws are tight.