DJI Phantom 2 Vision User Manual - Manual (Page 9)

©2014 DJI. All Rights Reserved. 9 |
indicating the remote controller and receiver is linking. Once fully linked, the power indicator will change
to a solid green.
(1)
(2)
(3)
(4)
If the low voltage warning alert sounds (refer to the Remote Control Power Indicator Status
Information (Page 9) ), please replace batteries as soon as possible.
Using the incorrect type of battery may prevent a risk of damage.
Remove the batteries after use and dispose of them safely.
For long term storage, be sure to remove the batteries from the remote control.
3.3 Remote Control Power Indicator Status Information
Power indicator Sound Remote Control State
None Functioning normally.
None Establishing a link between the remote control and the receiver.
B-B-B…… Low voltage (at 3.9V-4.5V), should replace the batteries immediately.
BBBB
Low voltage (lower than 3.9V). The remote control will automatically
power off. Batteries should be replaced immediately.
B-B-B……
The remote control will display a blinking green light and sound an alarm
after 15 minutes without operator input. The alarm status will disappear
once you start operation of the remote control.
The remote control will blink the LED and sound an alert when the voltage drops below 3.9V and
automatically power off after 3 seconds. This process will repeat even if you power cycle the remote
control. If this low voltage warning occurs during flight, the remote control will automatically power off
causing the aircraft to enter Failsafe mode, which cannot be interrupted (refer to the Failsafe Function
(Page 32) for details). It is strongly recommended to replace batteries if the 3.9V-4.5V low voltage
warning occurs.