DJI Phantom 2 Vision User Manual - Manual (Page 12)

©2014 DJI. All Rights Reserved. 12 |
The link between the remote control and aircraft is already established for you so you can initially skip this
procedure. If you ever replace the remote control, re-establishing the link is required.
Link Procedures
1.
2.
3.
Power off the remote control, power on the aircraft. You will see the link indicator blinking red.
Press the link button with a thin object and hold until the link indicator blinks yellow. Release the link
button.
Power on the remote control and the link indicator should switch off. This indicates that the link has been
successfully established.
Link Indicator
Link Indicator Description Operation
No signal received. Switch on the remote control or perform a link procedure.
In link status. Switch on the remote control.
3.7 Compliance Version Configuration
The compliance version can be reconfigured by twisting the potentiometer knob (See the following diagram) on the
back of the remote control using a flathead screwdriver. For CE compliance, set the remote control to CE
compliance by carefully turning the potentiometer knob to the full counter clock-wise position. For FCC compliance,
set the remote control to FCC compliance by carefully turning the potentiometer knob to the full clock-wise
position. Users should follow their local regulations accordingly.
接收机对频按键
&对频指示灯 Link Button &
Link Indicator