DJI Phantom 2 Vision User Manual User Manual

Page 54

54 |

High: 640



480@30fps

Medium: 640



480@15fps

Medium: 320



240@30fps

Low: 320



240@15fps (Recommended when there is a lot of interference.)

[5] Parameter Unit

Select imperial or metric units of measurement.

[6] Ground Station

Slide to the right to enable ground station feature.

[7] FPV Mode

Switched on, the gimbal will work in FPV mode.

Switched off, the gimbal will work in Stabilize mode.

[8] Compass Calibration

Tap to calibrate the compass. Do not calibrate the compass during flight.

[9] Dynamic Home Point

When activated, the Home point will be reset to your current position at specific time intervals. The aircraft will

return to the latest Home point as required.

[10] Current RTH Altitude

Default RTH altitude set to 20m. Raising the RTH altitude above 120m is not recommended.

[11] Battery History Info

Show the battery history warning records.

[12] Low Battery Auto Go Home

Enable or disable auto go home feature when battery is low.

[13] Rotation Lock

The user interface of the DJI VISION App will rotate if rotation lock is enabled (for iOS device only).

[14] Low Battery Warning

If enabled, an alarm will sound when the battery level is too low. Be sure sound is enabled on the mobile device

and try to adjust the volume to the highest level.

[15] Tutorial

Hints and Tips

[16] Clear News Cache

Tap to flush news cache.

[17] Binding

In the event the camera and range extender bind is lost or one of them requires repair or replacement, camera

and range extender binding should be performed via the DJI VISION App. Refer to the

for details.