DJI Phantom 2 Vision User Manual - Manual (Page 58)

©2014 DJI. All Rights Reserved. 58 |
12.6.2 Using Ground Station
Step 1 Launching Ground Station ：
Enable ground station feature from DJI Vision app Settings and a disclaimer for ground station prompts. Read the
disclaimer thoroughly before starting to use ground station.
Ensure your mobile device has access to the Internet. Due to the map data required, Wi-Fi connection is
recommended. Internet access is required to cache the ground station map, if Wi-Fi is unavailable, mobile data
service is required. Open the DJI Vision app camera GUI and swipe left to launch ground station. DJI Vision app
cannot connect to your aircraft while it is accessing the Internet. Hence, you may prompt with the warning message
such as “Connection to Phantom Failed”. This message will not appear when your aircraft is re-connected to DJI
Vision app. Map data of your current location will load. You can then drag the map to cache nearby areas for future
use.
Step 2 Setting a Waypoint ：
Disconnect from the Internet and connect the DJI Vision app to your aircraft. Check that remote control S1 switch is
in position (position-1) and the upper left corner in ground station display and wait for the aircraft to
enter “Ready-to-Fly” mode (LED indicator blinking green) before swiping left into ground station. Tap on the map to
place a waypoint. You can place up to 16 waypoints including the Home point. Waypoints cannot be placed beyond
500m from the Home point or inside No Waypoint Areas.