3 preparing the remote control, 1 the remote control, 2 power on the remote control – DJI Phantom 2 Vision User Manual User Manual
Page 8: Emote, Ontrol, Ower on the
©2014 DJI. All Rights Reserved.
8 |
3 Preparing the Remote Control
The PHANTOM 2 VISION remote control is a wireless communication device that uses the 5.8GHz frequency
band. It is compliant with CE and FCC (see the FCC ID) regulations and is set to Mode 2 before delivery. The
compliance version can be configured by twisting the potentiometer knob on the back of the remote controller.
The stick configuration can also be reset in the PHANTOM RC Assistant. Refer to the PHANTOM RC Assistant
and the
Compliance Version Configuration (Page 12)
for details.
(1)
(2)
(3)
CE compliant devices have an effective communication range of 300 meters in open spaces due
to power limitations. Be sure to watch your fight distance as the PHANTOM 2 VISION will enter
Failsafe mode (auto-landing or go home and land) if it flies beyond this range.
FCC compliant devices have an effective range of 500 meters in open spaces. Be sure to watch
your fight distance as the PHANTOM 2 VISION will enter Failsafe mode (auto-landing or go
home and land) if it flies beyond this range.
Pay attention to and follow local laws and regulations.
3.1 The Remote Control
[1]
[2]
[4]
[3]
[8]
[9]
[10]
J2
J1
J3
J4
[6]
[7]
[5]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
Antenna
Carrying Handle
Switch S1
Switch S2 (Reserved)
Joystick(J1: Roll [left & right], J2: Pitch [front & back])
Joystick(J3: Throttle [up & down], J4: Yaw [rotation])
Neck Strap Attachment
Power Switch
Power Indicator
Battery Compartment (On the back)
3.2 Power on the Remote Control
1.
2.
3.
Install the four AA Batteries (not included) into the battery compartment on the back of the remote
controller according to the negative and positive poles.
Set the S1 and S2 switches to the upper most position (position-1, refer to the
for details) and ensure both joysticks are at the mid-point position. Then toggle on the power switch.
There will be a power on indicator beep. If the remote control is set to be CE compliant, then there will be
one beep, while the FCC compliant version will emit two beeps. The power indicator blinks green quickly