Brandmotion 2000-3802 - Manual (Page 9)

Section 2: Chevy Tahoe/Suburban/Avalanche and GMC Yukon
Instructions, 2007 – Current
2000-3802 Instructions 10-11-12.doc Page 9 of 15
15. Set the DPS dip switches for your specific vehicle as
follows:
A) Chevy Tahoe/Suburban and GMC Yukon
Only. The first, second, and fourth switches
should be flipped to the “up” position – “UUDUD”.
(Figure 11)
Figure 11
B) Chevy Avalanche Only. The third and fifth
switches should be flipped to the “up” position –
“DDUDU”. (Figure 12)
Figure 12
16. Plug white 4-pin connector into DPS module and
wait 10 seconds. (Note: There should be no sound
from the speakers). Disconnect white 4-pin
connector from back of DPS module.
17. Plug white 4-pin connector back into DPS module.
After a few seconds you should hear sound from the
radio. Ensure radio head unit is working properly
including all speaker channels.
If you do not hear any sounds, recheck connections
and repeat Steps 13 through 17.
18. Disconnect negative battery cable.
19. Using supplied 24” wire ties, secure DPS module
under front of console or behind carpet on
passenger side upper foot well.
20. Reassemble vehicle.
21. Reconnect negative battery cable.
22. Place Bongiovi DPS Badge on the left side of radio
head unit. Chevy Tahoe/Suburban and GMC Yukon
Dip Switch Settings
Chevy Avalanche Dip Switch Settings