Brandmotion 2000-3802 - Manual (Page 7)

Section 2: Chevy Tahoe/Suburban/Avalanche and GMC Yukon
Instructions, 2007 – Current
2000-3802 Instructions 10-11-12.doc Page 7 of 15
1. Ensure all radio functions are working properly,
return all Treble, Bass, Fade, and Balance to
neutral settings, and remove any CDs to avoid
possible jam before disassembly.
2. For vehicles equipped with automatic transmissions,
place shifter in the N (neutral) position and set
parking brake.
3. Loosen the negative battery cable bolt. Remove
negative battery cable from terminal and position
away from battery.
4. Using a plastic trim tool, gently remove the IP center
trim. (Figure 1)
Figure 1
5. Using a 7mm socket driver, remove the 8 bolts
attaching the radio head unit and HVAC controls.
(Figure 2)
Figure 2
6. Pull out the radio head unit and disconnect the 16-
pin and 14-pin connectors from the back of the
radio. (Figure 3)
Figure 3
7. With the radio head unit pulled out of the way,
drop the white connectors of the DPS harness
though the opening behind radio cavity on the right
side (Figure 4). Move the console side panel aside,
and pull DPS harness through from underneath the
dash on passenger side.
Figure 4
8. Connect the male 16-pin and 14-pin connectors
from the DPS harness to the vehicle’s harness.
(Figure 5)