Brandmotion 2000-3802 - Manual (Page 14)

Section 4: Chevy Impala Instructions, 2006 – Current
2000-3802 Instructions 10-11-12.doc Page 14 of 15
9. Connect the female end of the 16-pin and 14-pin
connector from the DPS harness to the back of the
radio head unit. (Figure 6)
Figure 6
10. Connect the two white DPS harness connectors to
the DPS module. (Figure 7)
Figure 7
11. Connect the DPS turn-on switch to the remaining
connector on the DPS harness. (Figure 8)
Figure 8
12. Reconnect battery negative cable of vehicle.
13. Place DPS module with the Bongiovi DPS Acoustics
side face down. Then confirm the DPS Unit’s dip
switches are all set to the “down” position –
“DDDDD”. (Figure 9)
Figure 9
14. T urn vehicle ignition key to “ON” position. Turn on
radio head unit for 10 seconds. (Note: There should
be no sound from the speakers). Disconnect white
4-pin connector from back of DPS module. (Figure
10)
Figure 10
15. Set the DPS dip switches for Chevy Impala. The
first and third switches should be flipped to the
“up” position – “UDUDD”. (Figure 11)
Figure 11