Brandmotion 2000-3802 - Manual (Page 6)

Section 1: Chevy Silverado/GMC Sierra Instructions, 2007 – Current
2000-3802 Instructions 10-11-12.doc Page 6 of 15
16. Set the DPS unit’s dip switches for the vehicle’s cab
configuration:
A) For Regular Cab Trucks Only: The second and
fifth switches should be flipped to the “up” position.
“DUDDU”. (Figure 12)
Figure 12
B) For Extend Cab Trucks Only: The first, second,
and fifth switches should be flipped to the “up”
position. “UUDDU”. (Figure 13)
Figure 13
C) For Crew Cab Trucks Only: “DDUDU”. The third and
fifth switches should be flipped to the “up” position.
(Figure 14)
Figure 14
17. Plug white 4-pin connector into DPS module and wait
10 seconds. (Note: There should be no sound from the
speakers). Disconnect white 4-pin connector from back
of DPS module.
18. Plug white 4-pin connector back into DPS module.
After a few seconds you should hear sound from the
radio. Ensure radio head unit is working properly
including all speaker channels.
If you do not hear any sounds, recheck connections
and repeat Steps 14 through 18.
19. Disconnect negative battery cable.
20. Using the supplied 24” wire ties, secure DPS module
under front of console or behind carpet on passenger
side upper foot well.
21. Reassemble vehicle.
22. Reconnect negative battery cable.
23. Place Bongiovi DPS Badge on the left side of radio
head unit.