Brandmotion 2000-3802 - Manual (Page 13)

Section 4: Chevy Impala Instructions, 2006 – Current
2000-3802 Instructions 10-11-12.doc Page 13 of 15
1. Ensure all radio functions are working properly,
return all Treble, Bass, Fade, and Balance to
neutral settings, and remove any CDs to avoid
possible jam before disassembly.
2. For vehicles equipped with automatic
transmissions, place shifter in the N (neutral)
position and set parking brake.
3. Loosen the negative battery cable bolt. Remove
negative battery cable from terminal and position
away from battery.
4. Using a plastic trim tool, gently remove the IP center
trim. (Figure 1)
Figure 1
5. Using a 7mm socket driver, remove the 6 bolts
attaching the Radio head unit and HVAC controls.
(Figure 2)
Figure 2
6. Pull out the radio head and disconnect the 16-pin
and 14-pin connectors from the back of the radio.
(Figure 3)
Figure 3
7. With the radio head unit pulled out of the way,
drop the white connectors of the DPS harness
though the opening behind radio cavity on the right
side (Figure 4). Remove the passenger side console
panel, and pull through from underneath the dash.
Figure 4
8. Connect the male 16-pin and 14-pin connectors
from the DPS harness to the vehicles harness.
(Figure 5)
Figure 5