Brandmotion 2000-3802 - Manual (Page 11)

Section 3: Chevy Traverse, 2009 – Current Instructions
GMC Acadia, 2007 – Current Instructions
Buick Enclave, 2008 – Current Instructions
2000-3802 Instructions 10-11-12.doc Page 11 of 15
9. Connect the female end of the 16-pin and 14-pin
connector from the DPS harness to the back of the
radio head unit. (Figure 6)
Figure 6
10. Connect the two DPS harness white connectors to
the DPS module. (Figure 7)
Figure 7
11. Connect the DPS turn-on switch to the remaining
connector on the DPS harness. (Figure 8)
Figure 8
12. Reconnect negative battery cable.
13. Place DPS Module with the Bongiovi DPS Acoustics
side is face down. Then confirm the DPS unit’s dip
switches are all set to the “down” position –
“DDDDD”. (Figure 9)
Figure 9
14. Turn vehicle ignition key to “ON” position. Turn on
radio head unit for 10 seconds. (Note: There should
be no sound from the speakers). Disconnect white
4-pin connector from back of DPS module. (Figure
10)
Figure 10
15. Set the DPS dip switches for Chevy Traverse/GMC
Acadia/Buick Enclave. The first, second, third and
fourth switches should be flipped to the “up”
position – “UUUUD”. (Figure 11)
Figure 11