Brandmotion 2000-3802 - Manual (Page 12)

Section 3: Chevy Traverse, 2009 – Current Instructions
GMC Acadia, 2007 – Current Instructions
Buick Enclave, 2008 – Current Instructions
2000-3802 Instructions 10-11-12.doc Page 12 of 15
16. Plug white 4-pin connector into DPS module and
wait 10 seconds. (Note: There should be no sound
from the speakers). Disconnect white 4-pin
connector from back of DPS module.
17. Plug white 4-pin connector back into DPS module.
After a few seconds you should hear sound from the
radio. Ensure radio head unit is working properly
including all speaker channels.
If you do not hear any sounds, recheck connections
and repeat Steps 13 through 17.
18. Disconnect negative battery cable.
19. Remove passenger hush panel by using a 7mm
socket driver to remove the bolts.
20. Using supplied 24” wire ties, secure DPS module at
front of console. DO NOT mount module to shift
linkage or interfere with its operation. (Figure 12)
Figure 12
21. Reassemble vehicle.
22. Reconnect negative battery cable.
23. Place Bongiovi DPS Badge on the left side of radio
head unit.