Bowers Group Trimos Vectra Height Gauges - Manual (Page 34)

750 50 0002 03
34
Level of battery charge:
The level of the battery charge is indicated by a symbol:
a) 100% available power capacity
b) 75% available power capacity
c) 50% available power capacity
d) 25% available power capacity
e) The battery pack must be recharged
f) Attention! Not more than 5 minutes autonomous working
time is available.
a)
b)
c)
d)
e)
f)
Charging process:
After connection of the charging unit, the corresponding
symbol (plug) becomes active and the charge level is
animated. The charging process completed, the animation
stops and the symbol for the level of battery charge indicates
100% available power capacity.
Use only the charging unit supplied by Trimos to charge the battery pack of the instrument.
13.5 Test of luminous LED's
When switching ON the instrument, the LED's lights up for a short period of time. This is a functional test.
13.6 Measurement with / without air cushion displacement
The use of the air cushion facilitates the displacement of the instrument on the granite plate. The activation
of the air cushion lifts the instrument at about 2
µm. The air cushion is not only used for the displacement of
the instrument in general but also when performing measurements (e.g. diameters). The main application is
found particularly in industrial fields with large heavy parts. Small parts can be moved without activating the
air cushion. This allows to significantly increase the autonomy of the instrument.
When using the air cushion displacement for measurement procedures, all functions e.g. zero
or preset setting of the display should be done with air cushion to take into consideration the
lifting amount of the instrument.
13.7 Reset mode
If the instrument does not work properly, a reset is possible
using the Reset key located at the rear of the display unit.
This key can be reached through an opening by a pin of dia. 1
mm / length of 20 mm.