Bowers Group Trimos Vectra Height Gauges - Manual (Page 25)

750 50 0002 03
25
Angle between 2 center points and the X axes
1. Press the corresponding symbol
2. Enter the number of the 1
st center point (a)
3. Enter the number of the 2 nd center point (b)
4. Confirm by pressing Enter
The calculated values will be stored in the buffer as follows:
Number of the 2 center points
ANG 99-99
Angle (c) ANG 99° 99' 99"
1, 2, 3 …
Angle between 3 center points
1. Press the corresponding symbol
2. Enter the number of the 1
st center point (a)
3. Enter the number of the 2 nd center point (b) = highest
angular point
4. Enter the number of the 3 rd center point (c)
5. Confirm by pressing Enter
The calculated values will be stored in the buffer as follows:
Number of the 3 center points
ANG 99-99-99
Angle (d) ANG 99° 99' 99"
1, 2, 3 …
Table of the original measured values
This function allows to visualize all measured values used for
the coordinate system. Press the symbol shown at the right.
a) Number of the bore (shaft)
b) Coordinate relating to X
c) Coordinate relating to Y
d) Diameter (mean value relating to X and Y)
Close the function by pressing Enter.
Table of the calculated values
After selection of the required coordinate value system, the
bore (shaft) positions will be calculated. These true values
will be displayed in a table.
Press the symbol shown at the right.
Cartesian coordinates:
e) Number of the bore (shaft)
f) New coordinate relating to X
g) New coordinate relating to Y
h) Diameter (mean value relating to X and Y axes)
X
Y
c
a b
X
Y
d
a
b
c
a b c
a b c d
e f g h