Bowers Group Trimos Vectra Height Gauges - Manual (Page 29)

750 50 0002 03
29
10 Programmable function keys
The operating handle of the instrument includes one key to
activate the air cushion displacement of the instrument (Air)
and 2 programmable function keys, one yellow key (1) and
one blue key (2). The pre-programmed functions of this 2
keys are as follows:
a) Yellow key:
Preset
b) Blue key: Functions
Other functions can be allocated to these keys, see § 11.
11 Configuration (Set-up)
Certain parameters of the instrument can be configured
according to the user requirements.
To open this Set-up menu, press the Functions key longer
than 2 seconds.
> 2 sec.
The cursor keys allow the selection of the different elements
in the menu. The yellow arrow indicates the cursor position.
It is also possible to work directly using the touch screen.
The Enter key allows to activate / cancel the configuration
fields. The touch screen can as well be used.
For selection of the next page, press the Functions key,
To quit the Set-up menu, press the Enter key longer than 2
seconds.
> 2 sec.
Page 1
a) Locking of the measuring unit (mm or inch):
By activating one or the other field, the mm/inch key will
be locked in for one or the other measuring unit. The
instrument display will than only work in the selected unit.
b) Height of the setting gauge :
If another setting gauge than the supplied one will be
used, it is possible to enter its height.
The checking and storage of the constant must always be
done between 2 inverted surface without moving the
instrument or the reference gauge.
c) Angle unit format:
x.x°: Decimal degrees
x° x' x": Degrees, minutes, seconds
rad: Radians
d) Height of the gauge block for measuring angles:
By activating the required field, the last 2 steps of the
angle measurement will be cancelled. The height of the
gauge block will be taken over.
a
b
b
a
c
d