Bowers Group Trimos Vectra Height Gauges - Manual (Page 26)

750 50 0002 03
26
Polar coordinates:
i) Number of the bore (shaft)
j) Radius
k) Angle
l) Diameter (mean value relating to X and Y)
Before the request of changes in the coordinate system, the
true measured values are identical to those, mentioned in the
original table.
Close the function by pressing Enter.
Transfer of the calculated values to the buffer
All values listed in the table of calculated values can be
transferred to the buffer.
Press the symbol shown at the right.
The values of each bore (shaft) and their location will be
stored in the buffer as follows:
Cartesian coordinates:
Coordinate relating to X
X01 9999.9999
Coordinate relating to Y Y01 9999.9999
Diameter of the bore (shaft) D01 9999.9999
Polar coordinates:
Radius R01
9999.9999
Angle A01 999.9999
Diameter of the bore (shaft) D01 9999.9999
Close the two-coordinate measuring mode
To close the 2D measuring mode, press the symbol shown at
the right.
The 2D mode closed, the comment END 2D will be stored in
the buffer.
7.2 Management of the buffer contents
Getting started
This function allows to store the buffer contents, to recall it
and to perform a management of all stored items.
Open this mode by pressing the symbol of advanced
functions and then the symbol shown at the right.
Saving of a buffer contents
This function allows to save a buffer contents (values) into
the memory of the instrument. Press the symbol shown at the
right.
The saved memory file will be automatically named as
follows:
2000-09-23_17-30-35.txt (=date and hour)
Recalling of a saved buffer contents file
This function allows to recall a saved file and to reinstall
(copy) the items into the buffer. Select a file and press the
symbol shown at the right side.
i j k l