AJA FS2 Manual - Manual (Page 47)

FS2 v2.1r1 www.aja.com 47
1.1 Authentication
This parameter enables or disables an authentication login requirement. By default this
parameter is set to Disabled.
When you select Login via the front panel parameter, you must then go to the browser
interface to perform a login each time you access the FS2. The browser presents the login
screen first, requiring you to log in before you can access any other browser screens. The
password is initially set to the default value, but you can change it using the Remote
browser screen.
The default password is password.
NOTE: If authentication is used, it provides only a minimum security safeguard against
unauthorized use of the FS2. The authentication mechanism is simple and does not provide
robust security.
2.1–4 GPI IN 1–4
Response
The setting of this parameter determines what happens when a GPI trigger is received at
the FS2’s GPI Inputs (1–4). A GPI Trigger is defined as a TTL low voltage level (0 to 0.8V
with respect to its isolated ground pin). The GPI interface pinout and specifications are
Disabled (default)
Login
Disables the requirement for a login password. No password is
needed.
Login is required via the web browser interface before changes
can be made in FS2 configuration.