Rockwell Automation FactoryTalk Alarms and Events Quick Start - Manual (Page 26)

FactoryTalk Alarms and Events System Configuration Guide
18
• •
• •
•
Install and activate FactoryTalk software
Follow these procedures to install and activate the software products required for
FactoryTalk Alarms and Events.
This guide describes how to set up a local application. The procedure to set up a
network application is similar. This guide provides additional information about
Network applications where it is necessary. See also Appendix H, “Reference for
building a distributed system”.
For more information about each software product, see that product’s Help.
Typical stand-alone system
To use FactoryTalk Alarms and Events with a local application as part of a stand-alone
FactoryTalk system, install all software on the same computer. Use this diagram only
as a starting point; your own system will vary.