Rockwell Automation 2727-G7P20D1Q7 MobileView Guard G750 Quick Start User Manual
Page 22
22 MobileView Guard G750
Publication 2727-QS002E-MU-P
Inserting the PC Card
1. Unlocking PC card cover (see illustration 1).
a. Lay the MobileView with the display facing down onto a flat, clean table
(preferably on ESP pad). Take care not to damage the terminal and its
elements.
b. Lift up on locking lever until PC Card Cover is released.
2. Inserting PC card (see illustration 2).
a. Lift the cover up.
b. Insert the PC card until it locks in and the ejection button pops out.
3. Close and lock the cover (see illustration 3).
4. Press the cover down until it snaps in completely (see illustration 4).
ATTENTION
!
Verify that the corner of the PC card (with the notch) is
inserted into the slot on the side of the ejection button.
Check the condition and position of the cover seal before
closing the PC card cover.
Ejection button
1
2
3
4
Must snap
completely.
a
b
c
a
b
Locking Lever
PC Card Cover