Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 28)

Chapter 2
Installing DDMC32 Hardware Components
2-4
Installing DDMC32 Hardware Components when using a 6180 Industrial
Computer
To perform this task: Refer to this manual: Publication or Cat.
Number:
1. Install PLC-5 or PLC-5/250 and 1771 I/O PLC-5 Family Processor Installation
Instructions
Pyramid Integrator
Design/Installation/Startup and
Integration Manual
1785-10.4
5110-ISET
2. Install communications link:
a. Set the 6-switch assembly switches as follows:
1 2 3 4 5 6
OPEN X X X
C E X X X
Communication Interface Module
Installation Data 1784-2.31
CLOSED X X X
(Based on the factory’s setting, only switches 2 and 3
must be modified.)
Important: When installing and configuring your 6200
series software, the switch setting for “on” will
correspond to a 1 and the switch setting for “off” will
correspond to a 0.
b. Install Data Highway Plus Interface Module (cat. no.
1784-KT) into an ISA slot . 6180 Industrial Computer User’s Manual 6160-6.5.1
c. Connect the 1784-CP cable from the 6180 to the
PLC-5 or 5/250. PLC-5 Family Programmable Controllers
Hardware User Manual 1786-6.5.12
If using a multiple PLC-5 configuration:
Connect PLC-5 processors with cables and 3-pin
connectors
Pyramid Integrator Design/Installation/
Startup and Integration Manual 5110-ISET
Now that you have installed your hardware components, you can install
your software. Chapter 3 describes procedures for installing software for a
DDMC32 system. What to Do Next