Rockwell Automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE - Manual (Page 38)

1785-6.5.19 November 1998
4-8 Communicating via the Interface Module
00D5 Incorrect address for the local data table
0500 Message timed out waiting for a response from a client
1000 Illegal command specified in MSG instruction.
2000 Error communicating with a client
3000 Client session has disconnected
4000 Processor connected but faulted (hardware)
5000
Client generated an error converting data.
6000 Requested function is not available. Client’s unsolicited handler
returned an error.
7000 Processor is in program mode
8000 Processor’s compatibility file does not exist
9000 Client’s backlog has been exceeded
B000 Processor is downloading so it is inaccessible
F001 Processor incorrectly converted the address
F002 Incomplete address
F003
Incorrect address
F006 Addressed file does not exist in target processor
F007 Destination file is too small for number of words requested
F00A Target processor cannot put requested information in packets
F00B Privilege error, access denied
F00C Requested function is not available
F00D Request is redundant
F011 Data type requested does not match data available
F012
Incorrect command parameters
Code
(Hexadecimal - Word 1 of the control block) Description
(Displayed on the data monitor screen)