Rockwell Automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE - Manual (Page 30)

1785-6.5.19 November 1998
3-6 Configuring the Interface Module for Ethernet Communication
Based on this configuration, the BOOTPTAB file would look
like this:
Run your BOOTP server utility and then cycle power on the chassis
that contains the Ethernet interface module. This sends the
configuration information to the Ethernet sidecar module.
If you do not have access to a BOOTP server, Rockwell Automation
offers a BOOTP tool on http://www.ab.com/networks
# Legend: gw -- gateways
# ha -- hardware address
# ht -- hardware type
1
# ip -- host IP address
# sm -- subnet mask
# vm -- BOOTP vendor extensions format
2
# tc -- template host
#Default string for each type of Ethernet client
defaults5E: ht=1:vm=rfc1048
#Entries for 1785-ENET modules:
device1: tc=defaults5E:ip=12.34.56.1:ha=0000BC031234
device2: tc=defaults5E:ip=12.34.56.2:ha=0000BC035678
device4: tc=defaults5E:ip=12.34.56.4:ha=0000BC038827
#Entries for Ethernet PLC-5 processors:
device3: tc=defaults5E:ip=12.34.56.3:ha=0000BC1C9012
1. 1 = 10MB Ethernet
2. use rfc1048