Rockwell Automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE - Manual (Page 24)

1785-6.5.19 November 1998
2-8 Installing the Interface Module
Removing the Interface Module To remove the interface module from its installed position, follow the
instructions below.
Remove power to
the 1771 I/O chassis.
1.
Lift the locking bar up and away from
the processor and interface module.
2.
Lift the ejector tabs on the front of each
module simultaneously and remove the
connected modules.
3.
!
Remember to wear a grounding
wrist strap to guard against ESD.
Ejector
tabs
Loosen the four screws on the side of
the interface module.
4.
PLC-5
processor
Separate the interface
module from the processor
by placing your finger
tips between the two
modules. Pull directly
and evenly upward.
5.
Do not pry the interface module away from the
processor by pulling on one corner or side.
You will bend the connector header's pins.
!
Ethernet Interface Module