Necessary equipment – Rockwell Automation 1785-ENET USER MANUAL PLC-5 ETHERNET INTERFACE User Manual

Page 19

1785-6.5.19 November 1998

Installing the Interface Module

2-3

3. Locate and record the Ethernet hardware address.

Allen-Bradley assigns each PLC-5 Ethernet interface module an
Ethernet hardware address at the factory. Look for this
address either:

•

in the back, upper corner of your module

•

in the channel 3A configuration screen of your PLC-5
programming software

Necessary Equipment

Locate and have ready all the tools and equipment necessary
for installation:

19915

Ethernet
hardware
address label

I/O Chassis

(1771-A1B/B, -A2B/B, -A3/B or -A4B/B)

Any external or internal

Allen-Bradley power supply

ESD

Grounding

Wrist Strap

phillips

screwdriver

PLC-5 Processor

Supported processors and current firmware