Rockwell Automation 1771-N SERIES High Resolution Analog Module User Manual - Manual (Page 140)

Block Transfer Write and Block Transfer Read Configurations for 3 Output/5 Input 1771-N Series Modules G–8
Publication 1771ĆUM127B-EN-P - December 2002
Definition
Decimal Bit
(Octal Bit)
Word
Bit 06
Rate alarm. This bit is set if alarms are enabled and the output data
changed faster than the programmed ramp rate.
Bit 07
Bad data. This bit is set if BCD data format was chosen and output
value was not a legal BCD value.
Bits 08 (10)
Bad programming. This bit is set if the most recent BTW contained
improper programming data for this channel
Bit 09 (11)
Bad calibration. This bit is set if the channel has not had a valid
calibration.
Bits 10-14
(12-16)
Not used. Always 0.
Bit 15 (17)
I/O select bit.
0 = output,
1 = input.
This bit is set to 0.
Word 5
Bits 00-15
(00-17)
Channel 1 Raw data sent to DAC.
Words 6 and 7 Same as words 4 and 5, but for channel 2
Words 8 and 9 Same as words 4 and 5, but for channel 3
Bit 00
Underrange bit. This bit is set if the input signal is below the input
channels minimum range.
Bit 01
Overrange bit. This bit is set if the input signal is above the input
channels maximum range.
Bits 02-03 Not used. Always 0.
Word 10
Bit 04
Low alarm. This bit is set if alarms are enabled and the input signal
is lower than the low alarm setpoint.
Word 10
Bit 05
High alarm. This bit is set if alarms are enabled and the input signal
is higher than the high alarm setpoint.
Bit 06
Rate alarm. This bit is set if alarms are enabled and the input signal
changed at a rate faster than the input rate alarm setpoint.
Bit 07 Not used. Always 0.
Bit 08 (10)
Bad program. This bit is set if any of the channel level programming
data is illegal.
Bit 09 (11)
Bad calibration. This bit is set if the channel has not had a valid
calibration.
Bits 10-14
(12-16)
Not used. Always 0.
Bit 15 (17)
I/O select bit.
0 = output,
1 = input.
This bit is set to 1.
Word 11
Bits 00-15
(00-17)
Channel 4 input data.
Words 12 and 13 Same as words 10 and 11 but for channel 5.