Black Box LRU4240 - Manual (Page 196)

184 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
passive-interface INTERFACENAME (A.B.C.D)
INTERFACENAME = The name of the interface.
A.B.C.D = IP address of the interface.
Command Mode
Router mode
Usage
The passive-interface command is used to configure OSPF on simplex Ethernet interfaces. Since the simplex interfaces represent
only one network segment between two devices, configure the transmitting interface as a passive interface. This ensures that OSPF
does not send hello packets for the transmitting interface. Both the devices can see each other via the hello packet generated for
the receiving interface.
Examples
ospfd(config)# router ospf 100
ospfd(config-router)# passive-interface fxp0
Related Commands
redistribute
Use the redistribute command to redistribute routes from other routing protocols, static routes and kernel routes into an ospf
routing table.
Use the no form of this command to disable this function.
Command Syntax
redistribute PROTOCOL (METRICS|ROUTE)
no redistribute PROTOCOL
PROTOCOL= bgp|rip| ospf| connected|static|kernel
bgp Specifies BGP.
connected Specifies connected routes.
ospf6 Specifies OSPF v3. ( Visible only if OSPFv3 is enabled on the system)
rip Specifies RIP.
ripng Specifies RIPng. (Visible only if ripng is enabled on the system)
static Specifies static routes.
kernel Specifies kernel routes.
METRICS= [METRIC METRIC-TYPE]|[METRIC-TYPE METRIC]
METRIC= metric <1-16777214> (ROUTE)
METRIC-TYPE= metric-type <1-2> (ROUTE)
ROUTE= route-map WORD
WORD= pointer to route-map entries list. A route-map is a series of rule-sets defined in privileged Exec
mode.
Command Mode
Router mode
Usage
Examples
The following example shows redistribution of bgp routes into ospf routing table, with metric as 12.
ospfd# configure terminal
ospfd(config)# router ospf 100
ospfd(config-router)# redistribute bgp metric 12
Related Commands
refresh timer
Use the refresh timer command to adjust refresh parameters.
Use the no form of this command to disable this function.
Command Syntax
(no) refresh timer TIMERVALUE
TIMERVALUE = <10-1800> Timer value in seconds. The default refresh time is 10 seconds.
Command Mode