Black Box LRU4240 - Manual (Page 163)

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 151
unit modem
Use the unit monitor-jack command to set the monitor jack to net 1 or net2.
Command Syntax:
unit modem str1 WORD
unit modem str2 WORD
unit outage
Use the unit outage command is reserved to configure outage source event.
unit protect-mode
Use the unit protect-mode command to enable or disable changes from front panel.
Command Syntax:
unit protect-mode [enabled | disabled]
unit radius
Use the unit radius command to configure RADIUS client.
Command Syntax:
unit radius [primary-server | secondary-server] ip A.B.C.D
unit radius [retries | response-time] [1-3]
unit radius group-id WORD
unit radius protocol [yes | no]
unit remote-comm
Use the unit remote-comm command to set the remote communication protocol.
Command Syntax:
unit remote-comm [none | att | ansi]
unit sla
Use the unit sla command to configure Frame Relay SLA parameters.
Command Syntax:
unit sla [enabled | disabled]
unit sla [fdr-ddr-sample-period | delay-period] [1-255]
unit sla [fdr | ddr] threshold WORD
unit sla delay-packet-size [50-1500]
unit snmp
Use the unit snmp command to configure the SNMP community strings and the three Network Management unit.
Command Syntax:
unit snmp community [get } set | trap] LINE
unit snmp trap [1 | 2 | 3] A.B.C.D
unit snmp trap port [1 | 2 |3 ] [comm | net1 | net2 | bundle0 | enet]
unit yellow-alarm
Use the unit yellow-alarm command to enable or disable yellow alarm
Command Syntax:
unit yellow-alarm [enabled | disabled]
wan-port in-service
Use the wan-port command to enable or disable service on the NET1 and NET2 WAN ports.
Command Syntax:
want-port in-service [port1 | port2] [yes | no]