Rockwell Automation 140G-NTK-E12 LSIG and LSIG-MM Release - Manual (Page 26)

DIR 1000587R0002 (L3821)
(26)
Protection Parameter/Function
Enable StartUp ON / OFF
StartUp threshold
StartUp time
I Enable ON / OFF
Threshold I3
G Enable ON / OFF
Curve
Threshold I4
Time t4
Enable Trip ON / OFF
Enable StartUp ON / OFF
StartUp threshold
StartUp time
MM Enable ON / OFF
Threshold I5
U Enable ON / OFF
Threshold I6
Time t6
Enable Trip ON / OFF
OT Enable Trip ON / OFF
Load control Threshold 1
Enable ON / OFF
Threshold
Threshold 2
Enable ON / OFF
Threshold
Threshold lw
Enable ON / OFF
Threshold
Note: the characteristics of each single protection and their settings and corresponding curves, are explained in par. 3.1.9.
3.4.3 Measurements Menu
The following is a summary of the parameters accessible from the menu in the LSIG-MM units.
3.4.3.1 Measurements Menu table
Setting Parameter/Function Values Notes
Historical data
Trips Last trip (20)
Events Events log (80 events max.)
Measurements
I Max Maximum active current
Reset measurements
Peak
factor
Contact wear Percentage of wear on CB contacts
Waveforms I1, I2, I3 Graph, harmonics
N Graph, harmonics