Set date, Manual passage mode, Double code entry – SDC E72K-A CIVIC SERIES 160 User Electronic Digital Door Lock User Manual
Page 4: Temporary user schedule, Set time
P:\INSTALLATION INST\ELECTRIFIED LOCKSETS/INST-E72K-A/INST-E72K-A.vsd REV -
07-08 Page 4
This function will set the Month, Date and Year. There are two formats available: Standard (default MM-DD-YY)
or European (DD-MM-YY).
SET DATE
NOTE: FOR EUROPEAN DATE FORMAT SET: DD MM YY “0” (ZERO).
Enter MASTER CODE
#
*
*
*
13
MMDDYY
MANUAL PASSAGE MODE
This function puts the lock in an unlocked state, granting free egress (no code required) to all Users until the lock is returned to the
locked state. Returns to locked state at midnight and requires that the time be set (see “Set Time” below).
Enter MASTER CODE
#
ENABLE
*
30
*
*
1
Enter MASTER CODE
#
DISABLE
*
30
*
*
0
DOUBLE CODE ENTRY
For higher security the lock can be set to require that twoUser codes be entered before access is granted.
Enter MASTER CODE
#
SINGLE CODE
*
33
*
*
0
Enter MASTER CODE
#
DOUBLE CODE
*
33
*
*
1
This function allows you to restrict an existing Users’ access by a date range. Temporary User Schedules must be maintained or
access repeats annually. This function requires setting the date in the lockset (see “Set Date” below).
TEMPORARY USER SCHEDULE
“Delete Temporary User schedules” allows you to delete existing Temporary User Schedules. This will delete ALL Temporary
User Schedules.
DELETE TEMPORARY USER SCHEDULES
Enter MASTER CODE
#
*
06
0
*
*
ADD TEMPORARY USER SCHEDULES
Enter MASTER CODE
#
(Start Date)
*
*
*
06
(User ID)
MMDD
(End Date)
MMDD
*
This function will set the time (HHMM). Time is set in 24 hour format (example: 3:30pm = 1530).
SET TIME
Daylight savings time is enabled by default. To disable daylight savings, add a “0” (zero) at the end of the time entry.
(Example: 3:30pm = 15300)
Enter MASTER CODE
#
*
*
*
12
HHMM